ES-6133 Rev.9
R5-NP2
Remote I/O R5 Series
PROFIBUS-DP INTERFACE MODULE
(for 32-point analog signals)
MODEL: R5-NP2[1]
ORDERING INFORMATION
• Code number: R5-NP2[1]
Specify a code from below for [1].
(e.g. R5-NP2/Q)
• Specify the specification for option code /Q
(e.g. /C01)
[1] OPTIONS
blank
: none
/Q
: With options (specify the specification)
SPECIFICATIONS OF OPTION: Q
COATING (For the detail, refer to our web site.)
/C01
: Silicone coating
/C02
: Polyurethane coating
/C03
: Rubber coating
RELATED PRODUCTS
• PC Configurator cable (model: MCN-CON or COP-US)
• PC configurator software (model: R5CON)
• GSD (General Station Description) file
The GSD files and configurator software are downloadable at our web site.
GENERAL SPECIFICATIONS
Connection
PROFIBUS
: 9-pin D-sub connector, female
(Lock screw No. 4-40 UNC)
Internal bus
: Via the Installation Base (model: R5-BS)
Internal power
: Via the Installation Base (model: R5-BS)
Isolation
: PROFIBUS to internal bus or internal power
RUN indicator
: Bi-color (green/red) LED (refer to the instruction manual)
ERR indicator
: Bi-color (green/red) LED (refer to the instruction manual)
Data allocation
: Fixed to Mode 2
Configurator connection
: 2.5 dia. miniature jack
PROFIBUS COMMUNICATION
Interface
: PROFIBUS-DP, slave (RS-485 isolation)
Max. baud rate
: 12 Mbps
Transmission cable
: Approved for PROFIBUS-DP
Station address setting
: Rotary switch; 00 - 7D
(The station address is programmed to 7D if a larger number is set on the switches.)
• Special Clear Mode (Fail Safe Mode) is not supported. However, when the R5-NP2 is initialized
(when the power is turned on), the output of connected output modules is cleared by value “0”: the discrete outputs are turned off; the analog outputs are reset to 0 %.
INSTALLATION
Operating temperature
: -10 to +55°C (14 to 131°F)
Operating humidity
: 30 to 90 %RH (non-condensing)
Atmosphere
: No corrosive gas or heavy dust
Mounting
: Installation Base (model: R5-BS)
Weight
: 100 g (0.22 lb)
PERFORMANCE
Insulation resistance
: ≥ 100 MΩ with 500 V DC
Dielectric strength
: 2000 V AC @ 1 minute (PROFIBUS to internal bus or internal power)
STANDARDS & APPROVALS
EU conformity
:
EMC Directive
EMI EN 61000-6-4
EMS EN 61000-6-2
RoHS Directive
EXTERNAL VIEW
TRANSMISSION DATA DESCRIPTIONS
I/O DATA DESCRIPTIONS
The data allocations for typical I/O modules are shown below.
Refer to the manual for each module for detailed data allocations.
■ANALOG 16 BITS DATA
■ 16-POINT DISCRETE DATA
■ 4-POINT DISCRETE DATA
EXTERNAL DIMENSIONS unit: mm [inch]
SCHEMATIC CIRCUITRY & CONNECTION DIAGRAM